Jump to content
Posted 21 October 2016 - 03:42 PM
Posted 21 October 2016 - 04:28 PM
Posted 21 October 2016 - 05:05 PM
Posted 22 October 2016 - 05:40 AM
Posted 22 October 2016 - 02:42 PM
You can export and delete the BCD store and then run this option again. By doing this, you make sure that the BCD store is completely rebuilt.
To do this, type the following commands at the Windows RE command prompt:
Edited by FreeBooter, 22 October 2016 - 02:43 PM.
Posted 23 October 2016 - 12:19 PM
Posted 23 October 2016 - 12:24 PM
Posted 23 October 2016 - 01:24 PM
First type C: then try bcdedit /export C:\BCD_Backup command. You can use Dir command to find out if BCD store file exist in any partition hard drive may have use dir command like this Dir /s /a C:\BCD replace the drive letter for each partition. You can found list of partition and there assign drive letter by executing below commands.
Diskpart list disk Select disk 0 list volumes
Posted 23 October 2016 - 01:49 PM
Posted 24 October 2016 - 04:07 PM
Posted 24 October 2016 - 06:50 PM
Execute Dir command for C: and D: partition letters, you are looking for boot folder when you found this folder point Command Prompt to this "boot" folder drive letter for example if "boot" folder store at C: partition type C: and press Enter key and execute other commands to rebuild BCD store.
Repair The Boot Configuration Data For Your Pc is Missing or Contains Errors Message
Edited by FreeBooter, 24 October 2016 - 07:08 PM.
Posted 25 October 2016 - 06:05 AM
Posted 25 October 2016 - 06:11 AM
Posted 25 October 2016 - 08:28 AM
You need to found BCD file which store in Boot folder in System Partition. The attrib and Export command not working because the BCD file cannot be found.
Have you follow my instruction at below link.
0 members, 0 guests, 0 anonymous users