I was just wondering and kinda messing with it a fair bit, Okay, so you no how on a molex off a a older psu the floppy drive connector is connected and you can take it off by un hinging the clamps at the end of the cable when you pull the terminal out of the block connector...I have one of those but its a PCIE cable and it has the end that plugs into the corsair 750i and the other end plugs into the graphics card etc. well mine is one of the ones wit the the split ends on it, like the end that plugs into the graphics card splits in two so there are two 6+2 connectors. I was wondering if i could take that second cable off the same way as the floppy cable off a molex would? I no i can i have done it, you know? pulled the terminal out and undid the clamps pulled the cable up and cut it off then put it all back together. I am just wondering if this is safe to use and i no i no im not plugging it into my 780 until someone says its okay. But i need a 6 pin and a 8 and i want to just run 2 separate cables instead of that split thing. if anyone is confused about the way i described that or has no clue look up lutro0s video on molex sleeving he shows it in the very begining of the video
IF anyone can help it would be greatly appreciated THANKS!!!!