Hi, I want to set up a site to site VPN between my BEFSX41 (VPN enabled version) and my WRT54GL running Tomato Firmware and thus OpenVPN.
I followed this guide, and setup the server side (BEFSX41) with these exact settings (except the IP obviously, and other fields that require job specific values):
I then arrived back at college and went to go setup my WRT54GL with Tomato and found it much different in terms of settings. The only similarity that I can immediately notice is the field for "Server Address/Port" in which I put the server side's IP address. Other than that, I believe that I still need:
To set the encryption to DES and MD5 authentication
Set my pre-shared key (which happened to just be a word on the linksys setup)
Set the key lifetime to 3600
Set the Local Secure Group Subnet:192.168.2.0 and Mask:255.255.255.0
Set the Remote Secure Group Subnet:192.168.1.0 and Mask:255.255.255.0
If anyone could point me in the correct direction to connect an OpenVPN client to a Linksys VPN server, it would be a HUGE help. Thanks so much to any help.