This should do it.
The problem is actually based in your router.
Open MBAM in normal mode and click
Update tab, select
Check for Updates
Next disconnect your system from the internet, and your router, then…
Open MBAM in normal mode and click
Scanner tab,select
Quick scan and scan (normal mode).
After scan click
Remove Selected,
Next you must reset the router to its default configuration. This can be done by inserting something tiny like a paper clip end or pencil tip into a small hole labeled "reset" located on the back of the router. Press and hold down the small button inside until the lights on the front of the router blink off and then on again (usually about 10 seconds). If you don’t know the router's default password, you can look it up
HERE
However, if there are other infected machines using the same router, they will need to be cleared with the above steps before resetting the router. Otherwise, the malware will simply go back and change the router's DNS settings. You also need to reconfigure any security settings you had in place prior to the reset. Check out
this site here for video tutorials on how to properly configure your router's encryption and security settings. You may also need to consult with your Internet service provider to find out which DNS servers your network should be using.
Once you have ran Malwarebytes' Anti-Malware on the infected system, and reset the router to its default configuration you can reconnect to the internet, and router. Then return to this site to post your logs.
MBAM (MalwareBytes):
Please download
Malwarebytes Anti-Malware and save it to your desktop.
MBAM may "make changes to your registry" as part of its disinfection routine. If using other security programs that detect registry changes (ie Spybot's Teatimer), they may interfere or alert you. Temporarily disable such programs or permit them to allow the changes.- Make sure you are connected to the Internet.
- Double-click on mbam-setup.exe to install the application.
For instructions with screenshots, please refer to the How to use Malwarebytes' Anti-Malware Guide.
- When the installation begins, follow the prompts and do not make any changes to default settings.
- When installation has finished, make sure you leave both of these checked:
- Update Malwarebytes' Anti-Malware
- Launch Malwarebytes' Anti-Malware
- Then click Finish.
MBAM will automatically start and you will be asked to update the program before performing a scan.
- If an update is found, the program will automatically update itself. Press the OK button to close that box and continue.
- If you encounter any problems while downloading the definition updates, manually download them from here and just double-click on mbam-rules.exe to install.
On the Scanner tab:
- Make sure the "Perform Quick Scan" option is selected.
- Then click on the Scan button.
- If asked to select the drives to scan, leave all the drives selected and click on the Start Scan button.
- The scan will begin and "Scan in progress" will show at the top. It may take some time to complete so please be patient.
- When the scan is finished, a message box will say "The scan completed successfully. Click 'Show Results' to display all objects found".
- Click OK to close the message box and continue with the removal process.
Back at the main Scanner screen:
- Click on the Show Results button to see a list of any malware that was found.
- Make sure that everything is checked, and click Remove Selected.
- When removal is completed, a log report will open in Notepad.
- The log is automatically saved and can be viewed by clicking the Logs tab in MBAM.
- Copy and paste the contents of that report in your next reply. Be sure to post the complete log to include the top portion which shows MBAM's database version and your operating system.
- Exit MBAM when done.
Note: If MBAM encounters a file that is difficult to remove, you will be asked to reboot your computer so MBAM can proceed with the disinfection process. If asked to restart the computer, please do so immediately. Failure to reboot normally (not into safe mode) will prevent MBAM from removing all the malware.
Troubleshoot Malwarebytes' Anti-Malware