Why my video card stopped working after i a friend of mine cleaned it up? I am getting this message:?
"please check video cable connection."
First of all the onboard video card does not work, I was using a video card that i installed on a VGA slot. it worked fine for a long time up until:
1. My PC got full of viruses: I tried to clean my PC. by running antivirus software, and it did find and clean a bunch. However, it made it worse because afterwards, i couldn't even log in (the video card was still working fine). I put my XP CD and run the recovery console with some recovery commands, still no boot. I took my hard rive out, installed it on my other PC as slave and run check disk utility - still no luck. Run antivirus software from my other PC, and it did not find anymore viruses. However, my video card as i said, it was working fine by then.
2. I took it to friend's house so he could fix this boot problem that i had:
He told me he could not made the video card to work with his PC (he is a computer person).
3. I got it back to my House and decided it to reinstall my OS. When I boot the PC to reinstall XP again, I got this message: "please check video cable connection." And I said, that’s strange because it was working fine when i took it to my friend. I called him to ask him: "what did you do to it? "I cleaned the inside of it because it was all dirty - that's all I did” he said.
4. He and I then tried both, another VGA and PCI video card to see if it was the video card, but no luck (by the way, the PC was not posting - no beeps at all). He Took the CMOS battery for 10 seconds, and no luck. Disconnect the hard rive, DVD/CD drive, floppy drive, RAM, and still, no signal and no posting.
[b]
5. I Took all the components mention above with an addition to the video card to see if the PC would post, and nop, no posting at all (No beeps).
6. Finally, yesterday, I took the motherboard out and cleaned blowing air with my mouth (i did not have compress air jeje), put it back into the case. I tried it without RAM, hard drive, DVD/CD drive, floppy drive, to see if it would post, and without all these components all I hear is: One Long Beep After another one and it keeps repeating after 3 or 4 seconds.
I put the RAM back in it, power the PC back on and now BEEPS at all again. I tried it with the hard rive and DVD/CD drive AND NO RAM, and i get the same: One Long Beep After another one. So, only without the RAM I can hear those long beeps, but without the RAM, no beeps at all.
What can the problem be? Can someone please give me any suggestions? I need my PC! Please someone!! thanx in advanced!
"please check video cable connection."
First of all the onboard video card does not work, I was using a video card that i installed on a VGA slot. it worked fine for a long time up until:
1. My PC got full of viruses: I tried to clean my PC. by running antivirus software, and it did find and clean a bunch. However, it made it worse because afterwards, i couldn't even log in (the video card was still working fine). I put my XP CD and run the recovery console with some recovery commands, still no boot. I took my hard rive out, installed it on my other PC as slave and run check disk utility - still no luck. Run antivirus software from my other PC, and it did not find anymore viruses. However, my video card as i said, it was working fine by then.
2. I took it to friend's house so he could fix this boot problem that i had:
He told me he could not made the video card to work with his PC (he is a computer person).
3. I got it back to my House and decided it to reinstall my OS. When I boot the PC to reinstall XP again, I got this message: "please check video cable connection." And I said, that’s strange because it was working fine when i took it to my friend. I called him to ask him: "what did you do to it? "I cleaned the inside of it because it was all dirty - that's all I did” he said.
4. He and I then tried both, another VGA and PCI video card to see if it was the video card, but no luck (by the way, the PC was not posting - no beeps at all). He Took the CMOS battery for 10 seconds, and no luck. Disconnect the hard rive, DVD/CD drive, floppy drive, RAM, and still, no signal and no posting.
[b]
5. I Took all the components mention above with an addition to the video card to see if the PC would post, and nop, no posting at all (No beeps).
6. Finally, yesterday, I took the motherboard out and cleaned blowing air with my mouth (i did not have compress air jeje), put it back into the case. I tried it without RAM, hard drive, DVD/CD drive, floppy drive, to see if it would post, and without all these components all I hear is: One Long Beep After another one and it keeps repeating after 3 or 4 seconds.
I put the RAM back in it, power the PC back on and now BEEPS at all again. I tried it with the hard rive and DVD/CD drive AND NO RAM, and i get the same: One Long Beep After another one. So, only without the RAM I can hear those long beeps, but without the RAM, no beeps at all.
What can the problem be? Can someone please give me any suggestions? I need my PC! Please someone!! thanx in advanced!

Help
Welcome to BleepingComputer, a free community where people like yourself come together to discuss and learn how to use their computers. Using the site is easy and fun. As a guest, you can browse and view the various discussions in the forums, but can not create a new topic or reply to an existing one unless you are logged in. Other benefits of registering an account are subscribing to topics and forums, creating a blog, and having no ads shown anywhere on the site.

Back to top









