Help
hello everyone,
im trying to install LG DVD Rewriter on my PC.
ive followed the instructions on the manual on how to install it.
however, after i've turned on my PC, i got this message:
Press DEL to run Set-up
Press F8 for BBS set-up
512 MB OK (DDR: 553Mhz)
Auto-detecting Pri Master...IDE Hard Disk
Pri Master: WDC WD800BB-22JHC0 05.01C05
Ultra DMA Mode-5, S.M.A.R.T capable and status BAD
Pri Master Hard Disk: S.M.A.R.T. status BAD, Backup and Replace
Primary Slave Drive_ATAPI Incompatible
Press F1 to resume
**please, i need help on this**
i would really appreciate it if anyone would reply, thanks!!!
Page 1 of 1
Lg Dvd Rewriter Installation Problem
Back to top
#2
- Visiting Alien
-
- Group: BC Advisor
- Posts: 10,317
- Joined: 20-May 07
- Gender:Male
- Location:millenium falcon and rockytop
Posted 30 September 2008 - 01:20 AM
Welcome to Bleepin scarlett
WD hard drives have a special jumper setting when they are alone on the cable, it's called single drive
If you add another drive that messes it up
It's a bad idea to put a burner on the same cable anyway, like thrying to get 2 cars passing each other on a one lane bridge
I would install the burner jumpered master on the second cable, just pull the original drive(dvdrom whatever)
WD hard drives have a special jumper setting when they are alone on the cable, it's called single drive
If you add another drive that messes it up
It's a bad idea to put a burner on the same cable anyway, like thrying to get 2 cars passing each other on a one lane bridge
I would install the burner jumpered master on the second cable, just pull the original drive(dvdrom whatever)
Chewy
No. Try not. Do... or do not. There is no try.
No. Try not. Do... or do not. There is no try.
#3
- New Member
-
- Group: Members
- Posts: 2
- Joined: 30-September 08
Posted 30 September 2008 - 01:27 AM
DaChew, on Sep 30 2008, 01:20 AM, said:
Welcome to Bleepin scarlett
WD hard drives have a special jumper setting when they are alone on the cable, it's called single drive
If you add another drive that messes it up
It's a bad idea to put a burner on the same cable anyway, like thrying to get 2 cars passing each other on a one lane bridge
I would install the burner jumpered master on the second cable, just pull the original drive(dvdrom whatever)
WD hard drives have a special jumper setting when they are alone on the cable, it's called single drive
If you add another drive that messes it up
It's a bad idea to put a burner on the same cable anyway, like thrying to get 2 cars passing each other on a one lane bridge
I would install the burner jumpered master on the second cable, just pull the original drive(dvdrom whatever)
thanks for the reply...im gonna try your suggestion.
Share this topic:
Page 1 of 1